Hey guys. I have For Sale:

1 pair of Fox class 11 rear shocks. They are 2.0s with 11" 2.0 resevoirs. They have about 350 miles of racing on them and work great. A freshen up might be in order. hardware included. List $380, $240 for the pair.

4 complete type 1 axle assemblies for IRS. These 4 assemblies have stock vw cv outers, stock axles, cromoly stars, cromoly cages, and new hardened balls, new boots, grade 10.9 allen head cv bolts (and extras) that are drilled for safety wiring. The complete set of 4 were prepped each race and were rotated, so approximately 200 miles on each assembly. Will not seperate. All 4 complete sets (4 axles, 8 CVs) List ~$300, $150 for all.

This setup is great since you can have a fully loaded spare ready to go on the car or in the pits or both! We never had any problems with these and they look to be in good condition.

Pickup in San Diego, CA or additional shipping.

Mike, Where did you get the bolts that are pre drilled for saftey wire? That is something Jeremy and I would like to get.Were they the right length or did you have to cut them down? I would have to talk to Jeremy but how does 100 bucks and a certificate for $100 to Fox sound for the shocks? Maybe throw in a 6 pack of your favorite beer?

We had the mcmaster 10.9s drilled at a machine shop, the guy did an OK job. You guys could drill your own, use a small bit like 3/64" and put the hole deep, near the bottom of the allen hole. They were the right ones in length, I can't remember the dimensions but they are the same ones from mcmaster I think you guys have.

What's the deal with the fox certificate? Can I use it toward new shocks?

Cool on the bolts. I know the make a jig tool for drilling safety wire holes. As far as the certificate, yes, it can be used to purchase shocks. I will talk to Jeremy and call you later.

Michael F---ing Brenner.....OPEN BAR DUDE!!!!

Give me a call after 5 today. Hope you've cheered up...Pansy.


Careful dude, there's a beverage here man....

Michael,
Would you happen to still have the shocks and cv`s? I know it`s been awhile, but I am interested.

Tim<br><br>Post edited by: techteacher, at: 2007/06/16 01:30

hi im ernie in my 11 car im going to have a twenty two gallon fuel cell and a complete cage what mm rear torsions do u recomend